SkySwitch PRO NET for 10Micron Mounts — V3 Controller Version

SkySwitch PRO NET for the 10Micron V3 controller is a network-connected control and synchronization unit designed for remote and unattended observatories. It combines mount power control, GPS/PPS-based synchronization and live environmental data in one compact device.

This hardware variant is equipped with an integrated 1.5 m control cable terminated with a 6-pin AUX connector, as required by supported 10Micron V3 controllers. The cable is used by SkySwitch PRO NET to remotely switch the mount on and off and to provide direct hardware-status monitoring.

During normal operation, SkySwitch PRO NET communicates over wired Ethernet and continues performing its configured functions without requiring the Windows application to remain open.

Network-native observatory control

• Remote mount power control — safely switch the mount on or off over the network using the integrated AUX control cable.
• Direct hardware-status monitoring — monitor the operating state of a compatible V3 controller through the dedicated AUX interface.
• Native Ethernet connectivity — direct TCP/IP communication for reliable remote operation and diagnostics.
• Integrated GPS and PPS — provides validated UTC timing and geographic position data.
• Time and location synchronization — synchronizes UTC time, latitude, longitude and elevation with the mount.
• Environmental monitoring — supplies live temperature, pressure and humidity data for atmospheric refraction correction.
• Autonomous operation — configured synchronization and monitoring functions continue even when the Windows application is not running.
• Dark Mode — allows the Power and GPS indicators to be switched off for use near sensitive astronomical equipment.

Designed for the 10Micron V3 controller

This version of SkySwitch PRO NET is intended for compatible 10Micron mounts equipped with a V3 controller and 6-pin AUX connection. The integrated 1.5 m AUX cable provides the dedicated hardware connection required for remote mount power control and direct controller-status monitoring.

Mount communication, operational data exchange and synchronization are performed over the native 10Micron TCP/IP interface.

Please check your controller and connector type before ordering. If your mount uses a V2 controller with a 3.5 mm jack connection, select the dedicated SkySwitch PRO NET V2 version instead.

Simple configuration and reliable daily operation

Initial network configuration is performed through the dedicated USB SERVICE connection using the SkySwitch PRO NET application for Windows 11. Once a static network address has been saved to the device, normal operation requires only power and a wired Ethernet connection.

The application provides separate connection status for SkySwitch PRO NET and the mount, access to live GPS/PPS and environmental data, manual synchronization controls and configuration of autonomous operation.

Built for remote observatories

SkySwitch PRO NET was developed specifically for installations where dependable remote access is essential. Automatic connection and reconnection, autonomous synchronization and device-stored settings allow the system to resume normal operation after a computer or network restart.

For best GPS performance, install the device where its integrated antenna has a clear view of the sky.

What is included

• SkySwitch PRO NET V3 device
• Integrated 1.5 m mount control cable with a 6-pin AUX connector for remote switching and controller-status monitoring
• 6 V mains power adapter
• 1.5 m Ethernet cable

Key requirements

• Compatible 10Micron mount with a V3 controller
• Available 6-pin AUX connection
• Wired Ethernet network
• Available static IPv4 address for SkySwitch PRO NET
• Windows 11 computer for initial configuration, monitoring and firmware updates